Table-top Machines For Complex Test Jobs With Small Forc

? Zwick asia pvt ltd presents table-top machines for complex test jobs with small forc.The machines are designed for tensile, compression, flexure and cyclic tests. Two machines are developed for a nominal load of 5 kn, and another machine with a nominal load of 100 kn. The difference between the two 5 kn machines is to be found in the electronics and in the drive unit as well as with respect to the crosshead travel. The smaller one of the two machines with a maximum crosshead stroke of 423 mm is outfitted with the standard electronics with an output of 100 w. It is a low-cost alternative for test jobs with small forces specially for the paper and universal hardness test. The other machine is outfitted with standard electronics with an efficient drive unit of 500 w and is therefore, with a crosshead speed of 3,000 mm/min, especially suitable for elastomers tests. The third model is designed for a nominal load of 100 kn with standard electronics with an increased speed and an output of 2 kw. A typical range of application is the control of the goods received. This machine is a lowcost variant for simple cases of application compared to the 100 kn machine with the all-round-electronics used so far. All the three testing machines can be used with or without pc. When being used without pc, it will be a low-cost solution for standard cases of application. When being used with a commercially available standard pc and the software textxpert being very user-friendly, testing, analysis and statistical data processing are guaranteed. A wide range of accessories additionally permits a wide range of application